ӰԺ

Skip to Content
View site list

Profile

Pre-Bid Projects

Pre-Bid Projects

Click here to see Canada's most comprehensive listing of projects in conceptual and planning stages

US News

Biomimicry leads to winning design for DLR project

Don Wall
Biomimicry leads to winning design for DLR project
DLR - The Pinal County Attorney’s Office headquarters in Florence, Ariz. featured steel fins for shading and yellow pops of colour, mimicking desert flowers.

Award-winning architect Hans Papke and his team at Nebraska-based DLR Group had their work cut out for them when commissioned to design the new Pinal County Attorney’s Office HQ in Florence, Ariz.

As Papke, a senior associate at DLR, told a Toronto audience during a May presentation at the Urban Land Institute Spring Meeting, the owner wanted a new headquarters that would pull the best talent from the larger neighbouring counties.

The building would have to embody authority and empowerment, yet would have to reach out to the community as if they were family; and it had to be differentiated from the adjacent court building, since they did not want the public to think county attorneys are in cahoots with judges.

And all on a very tight budget.

Papke had his own goals — excellence in building performance, maximized energy efficiency, and capturing the beauty of the natural desert environment.

After a few walks in the desert, Papke decided that the architectural practice of biomimicry — in this case, mirroring the saguaro cactus, with its self-shading vertical fins — would enable the creation of a facility unlike any other in the region, with the cactus’s shading properties translated into tall steel sheets. And the desert flowers also inspired pops of yellow, to further distinguish the end result.

“As the sun moves around the cactus, the ribs protect itself and its skin from the heat of the sun,” Papke explained. “So parts of the valley, parts of the saguaro cactus, receive shade constantly throughout the day, which allows it to thrive in the desert with minimal water and moisture.

“I started looking at that and said, ‘you know, I think we need to look at using this.’”

Early focuses were on site location, building massing and orientation, energy performance, use of natural light, employee wellness and keeping costs low.

“In the end it’s important for the constituents to know that their money is going to something that’s good,” said Papke. “We got a lot of negative feedback before the building was built. ‘We were building a Taj Mahal in the desert,’ and everyone freaked out. This building came back at $400 a square foot so I don’t think I can build this building today for that.”

Discussions commenced on where to focus the budget. The west side faced the highway and had the potential to be a showcase, and the north side had beautiful views of the Superstition Mountains, so that’s where the money went.

DLR Group senior associate Hans Papke spoke at the recent Urban Land Institute Spring Meeting held in Toronto.
DON WALL – DLR Group senior associate Hans Papke spoke at the recent Urban Land Institute Spring Meeting held in Toronto.

“We looked at what can we do to reduce the building scale and make it the most optimized building footprint and plan possible.”

Through life-cycle, daylighting, energy and other analysis of four possible iterations, the final size was reduced to 56,000 square feet. High-partition cubicles that restricted light were done away with and sliding glass barn doors eliminated door swings and maximized daylight.

The floor-to-floor ratio was eventually reduced from 16 feet to 14.6 feet. The new “compressed” building was 14 per cent shorter and had 18 per cent less skin and 22 per cent less volume.

The decision was made to spend on heat-reflecting glass, and a breathable facade was created on the south side.

“The heat that goes beyond the metal panels acts as a chimney and goes up the building,” Papke explained, adding there are venting stacks so that the heat is not absorbed into the building.

Engineering the biomimicry was a final stroke. The team created a 3-D model of a saguaro cactus which confirmed that no part of the plant received more than 15 to 20 minutes of direct sun at any one time.

The building’s ribbed metal panel skin breaks up sunlight onto shifting areas, allowing the heat load to redistribute until natural air convection can cool the ribs.

“Biomimicry to me isn’t necessarily taking nature and just recreating it,” said Papke. “It’s looking at the strategy of what nature does and how it acts and how it thrives and using that in our buildings.”

Follow the author on Twitter @DonWall_DCN

Print

Recent Comments

comments for this post are closed